Home-case case
Posted: Sun Sep 26, 2021 10:58 am
The F. Seith gem I was fortunate to acquire came without a case. One of our grandsons carried it to the U.S. inside and in the center of a suitcase. A case was constructed:
A simple box was constructed of 1/2 inch (12 mm) pine boards for the edges, and 3/16 (5mm) inch plywood, glued and screwed together. This box was cut on a table saw to remove the top from the bottom of the case. Interior supports and partitions were then sawn from glued-up laminations of 3/4 inch (20 mm) pine. Latches and handle were from Amazon. Latches were also installed on the sides for extra security. This is a work in progress; final interior padding awaits installation.
Hope the attachments come across.
rudi
A simple box was constructed of 1/2 inch (12 mm) pine boards for the edges, and 3/16 (5mm) inch plywood, glued and screwed together. This box was cut on a table saw to remove the top from the bottom of the case. Interior supports and partitions were then sawn from glued-up laminations of 3/4 inch (20 mm) pine. Latches and handle were from Amazon. Latches were also installed on the sides for extra security. This is a work in progress; final interior padding awaits installation.
Hope the attachments come across.
rudi
- 654359603.jpg (528.34 KiB) Viewed 7347 times
- 654359459.jpg (563.21 KiB) Viewed 7347 times
- 654359431.jpg (593.72 KiB) Viewed 7347 times
- 654359522.jpg (775.44 KiB) Viewed 7347 times
